Mechanical Pre-Assembler - 2nd Shift

SUMMARY

Preparation of various shaft components for assembly of completed product.

SPECIFIC DUTIES

• Cut leaf sections to length according to engineering drawings and as directed by standard procedures.
• Deburr and radius ends of leaf sections for clean finish.
• Obtain pre-picked parts from holding area and verify correct part numbers as identified on material list.
• Assemble and crimp or stake button, lugs, and / or springs to leaf sections.
• Drill pin holes in lugs for loading at final assembly.
• Flame harden buttons and lug sections.
• Polish, roll stamp and deburr bodies.
• Spot face internal leaves for buttons according to engineering drawings.
• Counter sink external leaves to proper depth for required screws.
• Move completed work to proper holding area with identifying paperwork according to established quality control procedures.
• Maintain and record time sheets for each operation performed.
• Maintain neat and clean working area, inform supervisor of any equipment defects.
• Wear and maintain proper safety equipment including proper footwear, safety glasses, and hearing protection where required.
• Assist in other areas of manufacturing as required.
• Work in a safe manner at all times following established policies and procedures.

KNOWLEDGE, SKILLS, AND ABILITIES

PHYSICAL REQUIREMENTS

WORKING CONDITIONS

IND

Maxcess is an equal employment opportunity employer. We do not discriminate on the basis of race, religion, sex, disability, age, pregnancy, national origin, sexual orientation, or any other characteristic protected by applicable law. We are committed to diversity and inclusion, and all qualified candidates are encouraged to apply.