Control Wireman Technician

Job Description

Job Description

General Technologies, Inc., has an immediate openings for a Control Wireman Technician in our Fabrication department. The Control Wireman Tech is responsible for coordinating the assembly of wired panels according to established production quality standards and engineering specification. The ideal candidate must have a good understanding of point to point wiring concepts and the installation of a wide array of electrical / mechanical components.

Responsibilities (Include but are not limited to) :

• Perform point to point wiring for electrical control panels.
• Work from engineering drawings and schematics.
• Perform standard wiring procedures which include proper wire routing, stripping, crimping of lugs, torque terminal blocks per specification & proper wire termination.
• Will strip, crimp pins to wires and connect to housings, install hardware where needed.
• Using a multi meter and other test equipment, perform evaluations of electrical assemblies for continuity, current, functionality, and voltage.
• Attention to detail.
• Maintain a safe and clean working environment.
• Performs all other duties as assigned.

Educational and General Qualification Requirements :

Schedule :

Physical Demands :

The description below is intended to describe the general content and requirements for the performance of this job but is not limited to :

Some duties may be removed at any time and new duties may be added as GTI continues to grow. If and as required under federal or state law, upon request, reasonable accommodations which do not create an undue hardship will be considered, discussed, offered and implemented (if accepted) to enable persons with defined disabilities to overcome barriers to the performance of essential functions of the position.

Job Posted by ApplicantPro