Production GH

Job Description

Job Description

Position Summary

This position is responsible for general production in the area of production and packaging of the J. Skinner Baking Company’s food products. There are a range of duties in these food production lines that will be rotated every two hours.

Duties and Responsibilities( Essential functions, as defined under the Americans with Disabilities Act, may include the following tasks, knowledge, skills and other characteristics. This list of tasks is illustrative ONLY and is not a comprehensive listing of all functions and tasks performed by positions in this class. It does not imply that all positions within the class perform all of the duties listed, no

• Abide by all regulations, policies, work procedures, and instructions.
• Follow all safety rules and use all appropriate safety equipment.
• Take plastic clams out of case of clams and stack them on either side of the line, break down the case, then stack the broken-down case onto a cart for recycling.
• Take plastic clams off of stack of clams and place onto the line. This job is done first on one side of the line, then rotate position to the other side of the line.
• Take frozen product off conveyor belt and place into the empty clam going by the conveyor. This job is first done on one side of the line, then rotate position to the other side of the line.
• Pull off product from the line and place onto a rack when it came time for a label change or a possible line stoppage. After stoppage or label change, feed the product back onto the line from the rack.
• Case packing. There are two people, side by side, pulling the product off the conveyor at chest level and would place the product into a case at waste level. They would then push the full case, weighing approximately 18 pounds, onto the conveyor to be sent down the line.
• Separate out three sheets of four labels and would place the labels into the case of product for specific orders.
• On specific runs, make up a tray and place the tray on top of the case of product.
• All responsibilities and positions are rotated every two hours.
• At the end of the shift each person is responsible for general clean up.
• All other duties assigned.

Required Knowledge, Skills & Abilities To perform the job successfully, an individual should demonstrate the following competencies to perform the essential functions of this position.

Education & Experience

Physical Requirements

The physical demands described below are representative of those that must be met by an

employee to successfully perform the essential functions of this position. Reasonable

accommodations may be made to enable individuals with disabilities to perform the essential

functions.